There are a myriad of ways to personalize your dirt bike, UTV, UTV, or motorcycle's appearance - graphics and decals come in every shade and style. The choice of the designs you choose is the enjoyable and easy part, but putting them on could be a challenge in the absence of correct instructions.

How to Install Dirt Bike Graphics
Attack Graphics is a professional graphics shop that specializes in powersports. Their graphic designers are specialists in applying graphics to off-road vehicles. Here are the steps you need to follow to apply graphics in a straightforward manner that will guarantee that the graphics will stick.

Dry Set Up
1. Cleanse your hands, your plastics and the area you work in. Remove dirt and oil, as well as old adhesive and any other material from the front and back side of your machine's plastic. If you like to learn detailed information about dirt bike graphics, you must sneak a peek here at https://www.apzomedia.com/best-womens-dirtbike-riding-gear-fall-riding/ website.

2. Before applying before applying, trim the backing of the paper around the perimeter, making sure it is as closely as is possible (without actually cutting off the graphic). The paper backing should be taken away from bolt and vent holes. Check the alignment of the vents, holes, curves, and edges of your graphic with the plastic.

3. Remove the backing half and ensure that no dust or debris is deposited on the adhesive side. Cut the backing down the middle either horizontally for side plates or vertically for front plates. Use the remainder of the backing to cut a 1/2-inch piece. The remaining backing can be placed over the graphic. Line it up with gaps or edges.

4. Prevent the center strip from sticking as you align the graphic on the plastic. After it's aligned properly you can apply the center strip of the graphic onto the plastic.

5. The backing of the paper must be removed from one side. Hold the graphic in position and keep it away from plastic. Apply the graphic slowly by sliding your finger back and forth along the graphic, pressing out any air bubbles and wrinkles. To eliminate wrinkles and air bubbles you can use heat with a hair dryer or heat gun.

6. Remove the backing paper from the other side Apply the image as per step 4. For all other graphics follow the same steps.

Wet Installation
1. Be sure to wash your hands, plastics and the area you work in. Clean away dirt, oil, old adhesive, and any other material from the front and back side of your machine's plastic.

2. Before applying before applying, trim the backing of the paper around the perimeter to be as close to the graphic as possible (without cutting the graphic). The paper backing should be removed from the inside of the vent as well as the bolt holes. Verify that the lines of your vents, holes as well as the curves and the edges of your graphic against the plastic.

3. Apply a fine mist to your plastic.

4. Take the backing paper off your decal. Make certain to keep the adhesive free of dust, dirt and dust. Make use of a fine mist fluid to spray the adhesive side.

5. Lightly apply the decal onto the plastic, while filling up vent holes.

6. After everything is put in place, start from the center and move the liquid to the edges with a squeegee.

7. While you are continuing the squeegeeing process, you may use heat using a heat gun or hair dryer to speed up drying process. The use of heat can be utilized to smooth wrinkles and eliminate any bubbles.

8. To wipe any fluid left around the edges of plastic clean, dry clean cloth.

9. To ensure adhesion, it is advised to stay off your dirt bike, or quad for at least 24 hours.